Skip to main content
Derby
EGBD
PPR
Derby Aero Club +44 1283 733803
Location Derby Aero Club
Sea Level
MB
160
5
Derbyshire
Lat.
Long
6 Nm SW of Derby
52.859505
-1.6169
Lat. D-M-S
Long. D-M-S
Deg, Min, Sec
52°, 51', 34.22" N,
1°, 37', 0.84" W
Runways OHJ None Ft Circuit Height 1000 Ft
Heading
Circuit Direction
Length
Surface
05
RH
547 M
Grass

23

LH

547 M

Grass

10

RH

453 M

Grass

28

LH

453 M

Grass

17

RH

534 M

Grass

35

LH

534 M

Grass
Radio
Frequency
Callsign
Type
Other Radio
118.355
Derby Radio
Air Ground
East Mids APP
134.175
Details
Hours
Landing
School
Fuel
Other - See Remarks
Single £6.00 Twin £10.00
GA

AvGas

Remarks

None Radio Aircraft not Accepted
Derby Airfield is one of the newest airfields in the UK, the only one in Derbyshire. Built to replace Burnaston Airfield which was lost in 1990.
Planning permission for this site, which was farmland, took considerable effort and vast sums of money to obtain, allowing us to operate with very few conditions - however please DO NOT make it difficult for us by overflying the local villages, upsetting our neighbours and causing hassle which we could do without. Please call for PPR (as per UKAIP) and stick to the recommended circuit patterns (See website). These procedures also allow trouble free operation with East Midland's airspace in our vicinity.

Warnings

See website listed for PPR and circuit paterns.

Bad flying spoils it for everyone - so please don't!!!Also note the runway distances - check before setting out that you and your aircraft is capable of safe operation from our airfield.

Remember PPR by telephone before departure is essential for up-to-date airfield information and so we can give you a verbal briefing about our noise abatement (good neighbour) policy.
Thank you for complying and we hope you will enjoy our wonderful little airfield.

What's the Airfield like to Visit?

Click on a star to rate it!

Average rating 0 / 5. Vote count: 0

No votes so far! Be the first to rate this airfield.

Leave a Reply

Your email address will not be published. Required fields are marked *